STIHL Recalls Edgers, Trimmer/Brushcutters, Pole Pruners and KombiMotors
Name of Product:
STIHL gas-powered edgers, trimmer/brushcutters, pole pruners and KombiMotors
The gasoline tank vent can become dislodged due to incorrect factory installation and cause fuel to leak, posing a fire hazard.
November 12, 2015
About 140,000 (in addition, about 16,000 were sold in Canada)
This recall involves STIHL edgers with model number FC 56 C, trimmer/brushcutters with model numbers FS 40 C, FS 50 C, FS 56 C and FS 56 RC, pole pruners with model number HT 56 C and KombiMotors with model number KM 56 RC. The model number is located on the starter cover at the rear of the engine. The engine size is about 28 cc. The products are gray and orange with "STIHL" on the engine cover. The serial number range for all of the recalled units is 501830112 through 504083576. The serial number is located on the label on the bottom of the engine.
Consumers should immediately stop using the recalled products and return them to an authorized STIHL dealer for a free inspection and repair.
STIHL Inc. has received 319 reports of the fuel tank vents coming loose and fuel leaking. No fires or injuries have been reported.
Authorized STIHL dealers nationwide from November 2014 through September 2015 for between $200 and $400.
STIHL Inc., of Virginia Beach, Va.
About the U.S. CPSC
The U.S. Consumer Product Safety Commission (CPSC) is charged with protecting the public from unreasonable risks of injury or death associated with the use of thousands of types of consumer products. Deaths, injuries, and property damage from consumer product incidents cost the nation more than $1 trillion annually. CPSC’s work to ensure the safety of consumer products has contributed to a decline in the rate of deaths and injuries associated with consumer products over the past 40 years. Federal law bars any person from selling products subject to a publicly announced voluntary recall by a manufacturer or a mandatory recall ordered by the Commission.
For lifesaving information: